1. infusion pump operating procedures

1. The infusion pump is plugged into an external power supply.

2. Press the "Power On" button to turn on the power.

3. Install an infusion set on the infusion pump that has been filled with liquid medicine and discharged the gas in the pipeline.

4. Press and hold the "Infusion Set Selection" button, the "Infusion Set Indicator" light will be lit in cycles, and when the indicator light corresponding to the infusion set you want to use is on, release the button to complete the selection of the infusion set.

5. Set the infusion volume and flow rate (or number of drops).

6. Venipuncture for the patient.

7. Confirm the infusion volume and flow rate (or number of drops).

8. Press the "start" button of the infusion pump to start the infusion.

9. When the preset infusion volume is completed, the completion alarm will be triggered, and the machine will stop after pressing the "Stop" button, and the infusion will be completed.

10. Every 8-10 hours of continuous use, change the position of the infusion set in the pump to maintain high infusion accuracy.

2. Precautions and maintenance

1. Before use, make sure that the indicated infusion set is the same model as the infusion set that will be used. If the model does not match, press and hold the "Infusion Set Selection" button to select the same model. If the model of the infusion set is not in the table, calibrate it according to the "Infusion Pump User Manual", and fill in the corresponding model of each gear in the back table.

2. High-quality ordinary infusion sets with good elasticity should be selected for Infusion pumps, and infusion sets with poor elasticity will cause the infusion accuracy to decrease.

3. Wipe it in time after use to keep the infusion pump clean. If the sensor and bubble probe are blocked, the sensitivity will be affected and false alarms will be caused.

4. Due to the influence of factors such as the different viscosity of the liquid medicine and the deviation of the "number of drops/ml" parameter of the infusion set, it is normal for the "number of drops/min" to deviate in the actual infusion.

5. When the infusion pump is not used for a long time, it should be connected to the network power supply every 3 months to charge the battery, otherwise the battery may be scrapped if it is not used for a long time.

6. When an alarm occurs, press the "Eliminate Alarm" button to eliminate the alarm, and then pull the "Start/Stop" button again to start after eliminating the source of the fault.

7. The charging indicator light is on, indicating that it is charging fast.